NEC NEAX 7400 IMX Command Manual page 228

STM
Trunk Release
0
Sending ROT to the station upon receiving
1
1
CLR FWD signal (only for Russia)
2
3
4
Note: One setting applies to five items. (STM=0, STS 0)
Three-way calling with COT included
0
Three-way calling with COT included in Exec-
1
utive Right of Way service
Outgoing call to a C.O. Line or a Tie Line after
2
holding the COT
Outgoing call to a C.O. Line after holding a
3
station or a Tie Line
2
Processing for calling a fully-restricted station
after holding the COT
4
Processing in which ATT overrides to the con-
nection between the COT and a station (Busy
5
Verification) and then the Busy Verification
Warning Tone is sent out periodically
Step call when a Tie Line incoming call en-
6
counters busy
Remote Access to PBX/Automated Attendant
4 0
Day/Night mode changeover system
0
6 1
2
3
Not used
7 0
* = standard settings
Table 4-4 List for Assignment of ASTD (2/2)
STS
* = standard settings
ND-70348 (E)
ST
*
=standard settings
0 Station (Calling Party Release)
1 Trunk
Note: Valid when C.O. line has a release
signal. (Standard setting is "1".)
0 Restricted
1 Allowed
0 Restricted
1* Allowed
0 Restricted
1* Allowed
0 Restricted
1* Allowed
0 Restricted
1* Allowed
0 Restricted
1* Allowed
Note:
The call can be transferred.
0* Warning tone is sent out to both the station and
the ATT
1 Warning tone is sent out to the station, ATT,
and C.O. side.
0 Allowed
1 Restricted
0 Not provided
1* In service
0 Not used
1* Fixed to "1".
0*
0*
0*
0
1
ASTD
CHAPTER 4
Page 225
Revision 3.0