Apipn: Assignment Of Ip Address Data For Point Code For Ndm - NEC NEAX 7400 IMX Command Manual

APIPN: Assignment of IP Address Data for Point Code for NDM

1. General
This command is used to assign, delete, and readout the IP address data to the Point Code (PC) of the destination
node. IP address data is assigned for Netfusing services per a network. The data assigned by this command is
written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at each
Local Node (LN).
2. Precautions
1. This command is available for the software Release 9 or later.
3. Data Entry Instructions
Enter the Point Code of Destination Node.
DESTINATION
POINT CODE
(PC)
1-16367
CNT
CNT=2-8 is not used now.
Enter the IP address of the IPTRK card in the
Destination Node.
PC
COUNT
NO.
IP ADDRESS
(CNT)
1-8
1
2
IP ADDRESS
Select the either radio button.
• Permanent Virtual Connection
Keep TCP Connection permanently.
• Switched Virtual Connection
Disconnect TCP Connection when firmware does not
find a message on TCP transmitted/received in a
fixed time set by timer. (an ordinary mode)
MODE
TIMER
Used in Switched Virtual Connection.
Set the time passed until disconnecting
TCP Connection.
0: 15 minutes (default setting)
1-127: 1-127 minutes
Enter the Access Code.
This parameter is valid only when multiple
FCCS networks via CCIS service is available.
ND-70348 (E)
MODE
ACCESS CODE
TIMER (ADC)
0-127 MAX. 6 DIGIT
[0-9, , #]
*
ADC
APIPN
CHAPTER 4
Page 272
Revision 5.0