Acoc_Lr: Assignment Of Central Office Code – Logical Route Number - NEC NEAX 7400 IMX Command Manual

ACOC_LR: Assignment of Central Office Code – Logical Route Number
1. General
This command is used to assign C.O. line code and tie line code corresponding to particular trunks. Route Num-
ber of the ACOC command can be assigned by using Logical Route.
2. Precautions
1. Prior to this command, logical route data must be allocated by using the ALRTN command.
2. Only when logging in to the NCN (Network Control Node), this command can be used to assign the logi-
cal route data of self-Node and the other Nodes in the Fusion Network. If logging in to a LN (Local
Node), data setting only for the self-node is available. (Error message is indicated if you try to write the
data of other Node.)
3. The Central Office Code (COC) assigned by this command is displayed on ATTCON and also D
instead of the trunk number.
4. The COC assigned by this command is used to specify a trunk by the Individual Trunk Access service
feature.
5. This command affects the trunk route assigned the R/L = 1 by the ARTD command.
6. The Listed Directory Number (LDN) can be assigned as COC, and is convenient to identify the trunk.
7. This command is available since Release 9 software enhancement.
3. Data Entry Instructions
LOGICAL
ROUTE
POINT CODE
NUMBER
(LGRT)
1-899
FUSION
EXTERNAL
ROUTE
(FPC)
NUMBER
1-253
(RT)
TRUNK
NUMBER
(TK)
1-255
Enter 4 digits of Central Office Code.
ND-70348 (E)
DIGIT CODE
(DC)
REMARKS
MAX. 4 DIGITS
[0-9, *, #]
DC
ACOC_LR
term
CHAPTER 4
Page 472
Revision 3.0