Acsa: Assignment Of Connection Service Index A - NEC NEAX 7400 IMX Command Manual

ACSA: Assignment of Connection Service Index A

1. General
This command is used to assign the call termination for CAS Line and Direct-in Termination (Day Only).
2. Precautions
1. The ACFR command assignment is also required to accomplish the trunk incoming call termination service
feature.
2. CAS data at the Satellite Station
(a) It is necessary to set the TEC (Telephone Class) of the CAS Line to "15" in the ASDT command.
(b) A ring-down incoming call from a C.O line is terminated to the CAS Line.
3. When assigning CSIA=3 (Direct-in Termination-outside (Day Only)), the ADC should be assigned by the
ASPD command.
4. Use the ACSI command instead of this command if Direct-in Termination (Day and Night Mode) or Di-
rect-in Termination (Night Mode) is required.
5. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
3. Data Entry Instructions
1 = CAS Line
2 = Direct-In Termination(Day only)
3 = Direct-In Termination-Outside (Day only)
4-7 = Not used
TRUNK
ROUTE
NUMBER
NUMBER
(TK)
(RT)
1 0 0 1
2 0 0 1
CSIA
TERMINATING STATION
CONNECTION
SERVICE
INDEX A TENANT
(CSIA) NUMBER
1-7 (TN)
1 or 2 0 1
3
ND-70348 (E)
This parameter is required only for
CSIA=3.
STATION NUMBER
(STN)
0 3 1 1 1
ADC
ABBREVIATED
DIGIT CODE (ADC)
MAX. 4 DIGITS
0 0 1 1
CHAPTER 4
Page 574
Revision 3.0
ACSA