Aospl: Assignment Of Outgoing Selection Pattern For Ldm - NEC NEAX 7400 IMX Command Manual

AOSPL: Assignment of Outgoing Selection Pattern for LDM

1. General
This command is used to assign skip and additional digits information for Outgoing Selection Translation Pat-
tern Number (PNO). This data is written in Local Data Memory (LDM).
2. Precautions
1. Before using this command, make sure that an Outgoing Selection Translation Pattern Number (PNO) has
been assigned in the ASTPL command.
2. The transmit number translation of the OGC/OGCA method outgoing calls are done by ASTPL/AOSPL
command. Since the additional number and skip digits can be assigned by the AOPRL/AADCL command
for LCR/LCRS method, the ASTPL/AOSPL command may not be required.
3. Data Entry Instructions
Enter the PNO assigned by the ASTPL command.
OUTGOING SELECTION
TRANSLATION PATTERN NUMBER
(PNO)
1-15
Enter desired skip digits if required
PNO
NUMBER OF DIGITS
SKIPPED
(SKIP)
0-24
SKIP
Enter the number of digits to be entered in DC parameter.
If SKIP=0, ADD must be assigned to 1-4.
NUMBER OF ADDITIONAL
DIGITS
(ADD)
0-4
Enter desired additonal numbers within 4 digits.
ND-70348 (E)
ADD
ADDITIONAL DIGIT INFORMATION
(DC)
MAXIMUM 4 DIGITS
DC
CHAPTER 4
Revision 3.0
AOSPL
Page 255