NEC NEAX 7400 IMX Command Manual page 358

16. When using 16 ELCJ (SR 3295, PROG-B or later), the FKY = 49: Speed Calling-One Touch can be
assigned to a maximum of 16 Key Numbers (KYNS).
Note 1: Speed Calling-One Touch data can be saved by the BOSD command.
Note 2: Assign the data to the Key Numbers (KYN) in the consecutive order.
17. For Call Forwarding-Busy Line and Call Forwarding-Don't Answer, refer to ASYD SYS1 Index5 (sepa-
rate/common access for C.F.-Busy Line and C.F.-Don't Answer). If common access codes are assigned,
only one key is required to activate the features. If separate access codes are assigned, separate function
keys must be assigned.
term
18. <D 65>
term
<D 75>
Note: Each one-touch button is assigned a 2-page memory (Page 0 and Page 1). One destination number can be
assigned on a page basis. When originating an outgoing call, the page of one-touch button can be desig-
nated by this function key.
19. In conjunction with intercom service, take the following precautions:
(a) Before assigning the Intercom Key Data using this command, assign the Intercom Group Data using
the command AICD/ADIM.
(b) When providing the Intercom service, assign "The response priority when the SPEAKER button is
pressed or the station goes off-hook" in the parameter PRI. When not providing the Intercom service,
assign PRI = 0.
20. When this command is used, the ELC card must be reinitialized (MB switch UP-DOWN).
21. A maximum of 8 soft keys can be assigned via the function key (FKY=122).
Note: 6 soft keys available at the maximum when page scroll key soft key is displayed on the LCD.
22. Soft key data to be assigned via the function key (FKY=122) is not available for having the different func-
tion per each condition on the D
23. The same function data can not be assigned to both function key and soft key.
24. Expanded Multiple Line Operation - D
ment only when "KD = 0 (Line)" is entered. This service is not available when "KD = 1 (Intercom)" or
"KD = 2 (DSS Key)" is assigned.
The FKY = 55: One-Touch changeover (PAGE) should be assigned when registering
destination numbers greater than 20 as one-touch speed calling codes.
The FKY = 55: One-Touch changeover (PAGE) should be assigned when registering
destination numbers greater than 16 as one-touch speed calling codes.
term
.
term
ND-70348 (E)
[E-26] service is available since Release 8 software enhance-
AKYD_T
CHAPTER 4
Page 353
Revision 3.0