Atgll: Assignment Of Trunk Group Busy Lamp Data For Ldm - NEC NEAX 7400 IMX Command Manual

ATGLL: Assignment of Trunk Group Busy Lamp Data for LDM

1. General
This command is used to readout/assign/delete the controlling data of Trunk Group Busy Lamp which is accom-
modated on the Attendant Console. This data is written in Local Data Memory (LDM).
2. Precautions
1. The number of Attendant Consoles should be assigned by the ASYD command, SYS1, INDEX9.
2. The Trunk Group Busy Lamp lit when the trunk routes specified by the LGRT parameter of this command
are engaged.
3. The number of Trunk Group Busy Lamps to be applied (capable TGN data range) is assigned by the
ASYD command, SYS1, INDEX15, bit0-3.
4. This command is available for 16-IMG system only since Release 8 software enhancement.
3. Data Entry Instruction
Enter the Attendant Console Number assigned
by the ATRK command.
ATTTENDANT
NUMBER
(ATN)
1-30
Enter the Trunk Group Busy Lamp
Number on the Attendant Console.
ATN
TRUNK GROUP
BUSY LAMP
NUMBER
(TGN)
1-10
TGN
DATA
0 = Not registration
1= Registration
LOGICAL ROUTE
NUMBER
(LGRT)
1-899
LGRT
Enter the logical route number
composed the Trunk Group (TGN).
ND-70348 (E)
LGRT DATA
REMARKS
(DATA)
0/1
ATGLL
CHAPTER 4
Page 467
Revision 5.0