Arsc: Assignment Of Route Restriction Class - NEC NEAX 7400 IMX Command Manual

ARSC: Assignment of Route Restriction Class

1. General
This command is used to assign route restriction information according to the Route Restriction Class (RSC) of
the station and the Route Number (RT).
2. Precautions
1. Data can be entered on a Day/Night basis, if specified in ASYD command, SYS1, INDEX75, bit 0=1.
2. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data
of this command is common for all tenants (ASYD command, SYS1, INDEX92, bit4=1), assign TN pa-
rameter as data "1" for all tenants.
3. The displayed RSC (Route Restriction Class) corresponds to the one assigned by the ASDT command.
4. The details of each RRI are;
RRI
RRI-0
RRI-1
RRI-2
RRI-3
For the dummy route, assign the data to RRI3 only.
Note:
5. The restriction data (RES) is entered in the text box where RSC and RRI cross.
6. When RES=2 is assigned in RRI=3, ATDP/AARP (Toll Restriction 3/6 digits) should be assigned to spec-
ify the connection allowed area.
7. The parameter "RES" = 2 (Toll Restriction is allowed) is valid only when the parameter "RRI" = 3 (OG
Restriction Directly) is assigned.
Trunk incoming connection with an Attendant Console (or a station) assistance.
Trunk incoming connection without assistance.
Trunk outgoing connection with an Attendant Console (or a station) assistance.
Trunk outgoing connection without assistance.
Descriptions
ND-70348 (E)
ARSC
Note
CHAPTER 4
Page 292
Revision 3.0