Aasp: Assignment Of Administration Special Access Code - NEC NEAX 7400 IMX Command Manual

AASP: Assignment of Administration Special Access Code

1. General
This command is used to determine the Kind of Service to be executed or the route to be used when a Special
Access code or trunk Access code has been dialed for the Administration Station.
2. Precautions
1. This command is used for the Hotel Application only.
2. If the Guest and Admin. Numbering are separated (the ASYD command, SYS1, INDEX 160, bit6=0), use
this command for the Admin. Special Access code. For the Guest Special Access code, use the AGSP com-
mand.
Note: Hotel features are available in TN1 only. If the numbering plans are separated by tenants, the purpose for
each tenant is completely separated.
Admin. Station required of the guest room call must be allocated in TN1.
3. If the numbering plan for Admin. and Guest is common (the ASYD command, SYS1, INDEX 160, bit6=1),
this command may be used to assign the Guest Special Access code as well.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8. Enter
the tenant number in which this command effects.
If data of this command is common for all tenants (ASYD command, SYS1, INDEX 92, bit1=1), assign
TN parameter as data "1" for all tenants.
5. The access code for C.F.-Busy Line and C.F.-Don't answer service should be assigned by the ASYD com-
mand, SYS1, INDEX 5, bit0=0 (Same) or 1 (Separate).
6. The access code for Call Back and OG Trunk Queuing service should be assigned by the ASYD command,
SYS2, INDEX 4, bit0=0 (Separate) or 1 (Same).
7. To dial the different number of station number digits, the following programming is required.
For the station number (ex. 200, 20000),
Note:
AANP
AASP
8. The followings show the rules of NND/NND1 data for Speed Calling-System and Call Park Remote Re-
trieval.
Service Feature
Speed Calling - System
Call Park Remote
Retrieval Code
9. For following service features, the maximum number of digits is to be assigned in the parameter NND.
Account Code Dial
Authorization Code / Forced Account Code
Attendant Manual Override
10. The variable parameter appears on the MAT depending on the data in the parameter SRV.
1st.: 2 CI: N & H NND: 3
ACC: 200* CI: N & H SRV: SSC
SRV SID
SSC 15 NND is the number of digits of the
access code (ACC)
SSC 63 NND is the number of digits of the
access code (ACC)
Service Feature
SID: 36 STATE: 63 (Dummy STA)
NND
SRV
SSC
SSC
SSC
ND-70348 (E)
NND1
NND1 is the number of digits abbre-
viated digits code (ADC)
-
SID Max. NND
41 15
42 15
60 5
CHAPTER 4
Revision 3.0
AASP
Page 746