NEC NEAX 7400 IMX Command Manual page 717

SID
1 –
2 Dial Access to Attendant (Operator Call)
3 Camp on By Station
4-6 –
7 Call Pickup - Group
8-18 –
19 OG Trunk Queuing; Entry
20 OG Trunk Queuing; Cancel
The access code for the services marked * on Table 4-30 and Table 4-31 must be assigned with the same
Note:
number of digit if the access code begins using the same number. It is not available to assign different num-
ber of digit for the access codes (i.e. access code "100" and "10" cannot co-exist) in these services.
When SRV=SSCA (Service code appendix) is assigned;
SERVICE INDEX A (SIDA) 1-255
SIDA
1-49 –
50 UCD Busy Out; Entry *
51 UCD Busy Out; Cancel *
52-62 –
63 Call Pickup Expand
64-97 –
Internal Zone Paging; Originate
98
Note: Valid since Release 9
99-117 –
When SRV=OGC (Outgoing call) is assigned;
When SRV=OGCA (Outgoing call with route advance) is assigned;
CNT (1-15) LOGICAL ROUTE NUMBER (LGRT)
1
2
3
Table 4-30 SID (ASPAN)
SERVICE NAME
Table 4-31 SIDA (ASPAN)
SERVICE NAME
LOGICAL ROUTE NUMBER
SID
21-36 –
37* Priority Call 1
38* Priority Call 2
39* Priority Call 3
40-60 –
61 Call Park; Entry
62 Call Park; Local Retrieve
63 Call Park; Remote Retrieve
Refer to Table 4-31 SIDA (ASPAN).
Note:
Only 50, 51, 63 are available for the software Release 3.
SIDA
Calling Party CLIR/CLIP Control
118 *
Note:
119 –
120 Selectable Station Call Pickup
121 Selectable Station Call Pickup Group
122 –
123 IP Enabled Dterm Password Entry (for IPX)
124-255 –
(LGRT)
CNT is the route advance order.
ND-70348 (E)
SERVICE NAME
SIDA
SERVICE NAME
Valid since Release 8 for Australia only.
CNT
ASPAN
CHAPTER 4
Page 678
Revision 5.0