Asipn: Assignment Of Station Of Ip Data For Ndm - NEC NEAX 7400 IMX Command Manual

ASIPN: Assignment of Station of IP Data for NDM

1. General
This command is used to assign and delete the IP-ELC terminal data of each station. It is also used to read out
the already assigned data and the data can be modified. The data is written in Network Data Memory (NDM) of
the Network Control Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. If any wrong data is input, error message "LP H/I Error (Error Code 0x0E03)" is indicated.
2. If the IP Enabled Dterm station is busy, error message "Line Busy" is indicated.
3. If the IPELC card is not mounted, error message "IPELC data invalidity (Package is not mounted) (Error
Code 0x0A1F)" is indicated.
Note:
In case (1) (2) (3), the office data is to be assigned.
4. It is required to initialize the IPELC card to validate the data assigned by this command.
5. This command can be used since Release 10 software enhancement.
6. Parameters "PRIn PAYLOAD_TYPE" and "PRIn PAYLOAD_SIZE" are available for IPELC Voice Com-
press feature in IPX system.
3. Data Entry Instructions
Enter the Telephone Number of each IPELC
terminal (DtermIP station) within 16 digits.
USER
TELEPHONE NUMBER
GROUP
NUMBER
MAX. 16 DIGITS [0-9, *, #]
(UGN)
Note 1:
JB_MIN data must not exceed the JB_MAX value.
PD JB_MIN, JB_MAX (JB_MIN=JB_MAX)
PD (JB_MIN+JB_MAX) /2 (JB_MIN
Check the "DETAIL" box in case assignment for detail information is required. If "IPG=0" is entered, the
Note 2:
three parameters are all necessary and the "DETAIL" box might automatically be checked.
*Continued on the next page.
TELN
(TELN)
IPG
Enter the IPELC Group data.
10ms × n (1 n 30)
IPELC JITTER
GROUP
BUFFER
DATA(IPG)
MIN
0-127 (JB_MIN)
JB_MAX)
ND-70348 (E)
JB_MIN/JB_MAX/PD
Note 1, 2
PRIMARY
JITTER
BUFFER
DELAY
MAX
(PD)
(JB_MAX)
[1-30]
ASIPN
REMARKS
CHAPTER 4
Page 652-4
Revision 5.0