Anpdl: Assignment Of Numbering Plan For Ldm - NEC NEAX 7400 IMX Command Manual

ANPDL: Assignment of Numbering Plan for LDM

1. General
This command is used to assign the minimum number of digits needed to determine the service which is re-
quired to the first digit received (pre-translation).
2. Precautions
1. This command is used for the Business Application.
2. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
Enter the tenant number in which this command effects.
If data of this command is common for all tenants (ASYDL command, SYS1, INDEX800, bit2=1), assign
TN parameter as data "1" for all tenants.
3. Use the this command to assign the numbering data for the operator call and the priority call (terminating
to ATT) in the Netfusing Network.
4. The numbering data for Telephone numbers may be programmed by this command, however, those Tele-
phone numbers are available in the self node only.
Telephone numbers available within the Netfusing Network are to be programmed at Network Control
Node (NCN) by using the ANPDN and ASPAN commands. For more details, see "Netfusing System Man-
ual".
5. The system data assignment (ASYDL, SYS1, INDEX 513, bit0=1) is necessary for using the ANPDL com-
mand.
ND-70348 (E)
ANPDL
CHAPTER 4
Page 230
Revision 3.0