NEC NEAX 7400 IMX Command Manual page 489

3. Data Entry Instructions
0=30 seconds, and then disconnects
1=The connection is held until the calling party released
TENANT ANNOUNCEMENT
NUMBER EQUIPMENT
(TN) NUMBER
(EQP)0-127
Enter EQP as the service feature provided by DAT.
0=Dead Level Number
1=Unused Number
2=Remote Access to PBX
3=May be used for other purposes
4=Outgoing Trunk Busy Announcement
5-6=May be used for other purposes
7=Route Restriction Announcement
8-14=May be used for other purposes
15=Alert Service(for Hotel system)
16=Timed Reminder Set Message (for Business system)/
Service Set-up Message (for Hotel system)
17=Service Set-up Failure Message (for Hotel system)
18=Timed Reminder Cancel Message (for Business system)/
Service Cancel Message (for Hotel Massage)
19=Service Cancel Failure Message (for Hotel system)
20=Room Cut-Off Announcement (for Hotel system)
21=Do Not Disturb Announcement (for Hotel system)
22=Timed Reminder/Wake Up Call Message for Announcement Trunk
23-31=Group Announcement (for Hotel system)
32=Delay Announcement-Attendant (for U.S.A./Canada only)
33=Not Used
34=Automated Attendant (1st Announcement)
35=Automated Attendant (2nd Announcement)
36=Slumber Time-Do Not Disturb (for Slumber Time Group 1)
37=Slumber Time-Do Not Disturb (for Slumber Time Group 2)
38=Slumber Time-Do Not Disturb (for Slumber Time Group 3)
39=Slumber Time-Do Not Disturb (for Slumber Time Group 4)
40=Slumber Time-Do Not Disturb (for Slumber Time Group 5)
41=Slumber Time-Do Not Disturb (for Slumber Time Group 6)
42=Slumber Time-Do Not Disturb (for Slumber Time Group 7)
43-48=Not Used
49-53=Delay Announcement Attendant (1st Announcement)
54-58=Delay Announcement Attendant (2nd Announcement)
59-121=Not Used
122-125=Multiple Announcement
126-127=Not used
When "M=0 (Single connection)" is selected, assign "R=1 (Do not send RBT)."
Note:
C
DURATION OF
CONNECTION
(C)
0/1
EQP
Note:
changeable by the AHSY command,
though the default EQP (service name)
are listed here.
Note
Note
Note
Note
Note
Note
Note
R
0=Send RBT
1=Do not send RBT
0=Answer Signal is not sent
1=Answer Signal is sent
ANSWER
SENDING MULTIPLE
SIGNAL
RBT CONNECTION
SENDING
(R)
(A)
0/1
0/1
The EQP for Hotel system is
Note
ND-70348 (E)
LGRT
Enter logical route number.
A
LOGICAL
ROUTE
NUMBER
NUMBER
(M)
(LGRT)
0/1
1-899
M
0=Single connection
1=Multiple connection
TK
Enter TK data.
Note: This parameter
appears if M=1 is
entered.
AAEDN
TRUNK
(TK)
CHAPTER 4
Page 482
Revision 5.0