Adrtl: Assignment Of Dterm Display Route Data For Ldm - NEC NEAX 7400 IMX Command Manual

ADRTL: Assignment of D
1. General
This command changes the display of trunk class information on the D
designation of the ARTD command.
2. Precautions
1. The data assigned in this command affects the stand alone-node and Local Node (LN).
2. When this data is assigned to Local Data Memory (LDM) in the Netfusing Network, if Network Data
Memory (NDM) has Display Route Data designated by the ADRTN commands, NDM data overrides
LDM data.
3. The data assigned by this command is not available for ISDN stations and PS.
4. When a call terminated from the trunk COC number has been assigned by the ACOC command, the fol-
lowing is displayed on the D
• TYPE = 1 (4 characters) is entered, both COC number assigned by the ACOC command and 4-char-
acter trunk class assigned at "DISP" parameter is displayed.
• TYPE = 2 (8 characters) is entered, only the 8-character trunk class assigned at "DISP" parameter is
displayed.
3. Data Entry Instructions
Assign Physical Route number at the non-Fusion
node.
Note: For Fusion node, assign Logical Route number
using the ADRTN command.
Route
Number
(RT)
TYPE
The maximum number of characters
1 = 4 (4 bytes ASCII characters)
2 = 8 (8 bytes ASCII characters)
term
Display Route Data for LDM
term
as to "TYPE" parameter;
RT
Character
Display for Trunk Class on D
Display Type
(TYPE)
1, 2
DISP
The characters displayed on the D
(DISP)
ND-70348 (E)
term
instead of the Trunk Class (TCL)
term
.
term
REMARKS
ADRTL
CHAPTER 4
Page 368
Revision 3.0