Annd: Assignment Of Necessary Digits Data - NEC NEAX 7400 IMX Command Manual

ANND: Assignment of Necessary Digits Data

1. General
This command is used to assign the necessary number of digits for particular trunk route.
2. Precautions
1. This command is needed when the originating call uses both OG mode and signaling as follows;
(a) ASPA command SRV = OGC/OGCA
(b) ARTD command OSGS = 4/6/7 (Sender Immediate Start/Sender Delay Dial Start/Sender Wink Start)
2. When the number of the digits for an originating call specified by the NND parameter is dialed, the follow-
ings are occurred concurrently.
(a) The SND circuit starts to transmit the number information to the external trunk route.
(b) The Originating Register (ORT) circuit is released.
3. The NND parameter assigned by this command determines the number of necessary digits to be received
by the originating register (ORT) circuit.
4. The data entered in NND parameter should be included the number of digits of the trunk access code.
3. Data Entry Instructions
ROUTE
NUMBER
(RT)
I=Incoming (Not used)
O=Outgoing
INCOMING/
OUTGOING
CALL
(IC/OG)I/O
IC/OG
Enter desired number of necessary
digits.
NUMBER OF
NECESSARY
DIGITS
(NND)1-24
ND-70348 (E)
NND
REMARKS
ANND
CHAPTER 4
Page 249
Revision 3.0