Apcr: Assignment Of Primary Call Restriction Data - NEC NEAX 7400 IMX Command Manual

APCR: Assignment of Primary Call Restriction Data

1. General
This command is used to assign the restricted area code for LCR outgoing call.
2. Precautions
1. The restriction check by this command is to be executed prior to the ARSC/ATDP/AARP commands.
2. The restricted area code assigned in PDC parameter can be numbers (0 - 9, * and #) or the mask code "X"
which represents all kind of numbers (0 - 9, * and #), or "P" for a pause.
3. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data
of this command is common for all tenants (ASYD command, SYS1, INDEX94, bit2=1), assign TN pa-
rameter as data "1" for all tenants.
4. The outgoing call from Attendant Console cannot be restricted.
3. Data Entry Instructions
BLOCK
Unique Block Number should be assigned.
TENANT
NUMBER
NUMBER
(BLOCK)
(TN)
BLOCK
PRIMARY CALL
DIGIT CODE
(PDC)
0-49
MAX. 24 DIGITS
RESTRICTION DATA(RES) is assigned in the squares where RSC and
PDC cross. When unassigned allowed Status.
0=Restricted
1=Connection is allowed
PDC
PDC should include the Access Code.
ROUTE RESTRICTION CLASS (RSC) 0-15
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
ND-70348 (E)
RES
APCR
CHAPTER 4
Page 307
Revision 5.0