Direct Output/N-1 Section; Assigning The Output Section - Studer D950 Operating Instructions Manual

D950 Digital Mixing System
3.3.4 Direct Output/N–1 Section
INPUT DIR OUT
IN 1 ON
Input Out
IN 2
Busses
GEN
Meters
1 2
ON ON
AUX
MONO
3 4
ON ON
1 2
ON ON
AUX
STEREO
3 4
ON ON
3.3.4.1

Assigning the Output Section

OUT/
INPUT
N-1
EQ FILTER
EQ2
LIM/ EXP/
COMP GATE
INSERT DELAY
MONO ADD.
AUX AUX
STEREO
PAN
AUX
PAGE PAGE
1 2
PAGE PAGE
3 4
AUTO
SHOW
ASSIGN
VALUES
MODES
FREEZE LINK
OFF ACCESS
MENU
3-22 Desk Operation
DIR OUT Using the DIR OUT key, the channel's Direct Output can be switched
ON/OFF. The following parameter is available for the Direct Output:
• Direct Output level
Notes: The Direct Output is available for all channels for which it has been con-
figured.
The Direct Output cannot be defeated on MASTER or AUX channels.
The Direct Output can be fed from the following channel locations (refer
to chapter
• After the channel input
• Pre-fader
• After-fader.
A. Global Assignment:
• Press OUT/N–1 on the Master Menu Selector.
Displays of all Channel strips will switch over and indicate output
control parameters, except those in FREEZE mode; see
• PAGE 1 is the only page available.
B. Local Assignment on the channel strip:
• Press ASN SEL; the ASN SEL key will flash.
• Press the DIR OUT key. The DIR OUT parameters will be displayed
on the LACP (= PAGE 1 only).
C. Local Assignment affecting all channel strips:
• Press LINK ACCESS on the Master Menu Selector.
• Pressing a local assignment key will now affect all Channel Strips. The
same functions as described in "B" are available.
D. Local Assignment with Auto Assign Modes "In-Only":
• Press AUTO ASSIGN MODES on the Master Menu Selector once
(AUTO ASSIGN MODES is illuminated).
• Pressing the DIR OUT key on the channel strip will assign the DIR
OUT parameters to the LACP without pressing the ASN SEL key,
provided the function toggles to an IN (or ON) status. If it toggles to an
OUT (or OFF) status, the knob status does not change.
E. Local Assignment with Auto Assign Modes "In and Out":
• Press AUTO ASSIGN MODES on the Master Menu Selector twice
(the AUTO ASSIGN MODES key and the ASN SEL keys on all the
channel strips are illuminated).
• Every time the DIR OUT key on the channel strip is pressed (regard-
less of what status it toggles to), the DIR OUT parameters are assigned
to the knobs on the LACP).
Note: AUTO ASSIGN MODES and LINK ACCESS may be engaged at the same
time.
SW V3.3
4.4.3.5):
chapter 3.3.2.
Date printed: 03.09.03