Delay Parameters; Delay Time - Studer D950 Operating Instructions Manual

INPUT DIR OUT
IN 1 ON
Input Out
IN 2
Busses
GEN
Meters
1 2
ON ON
AUX
MONO
3 4
ON ON
1 2
ON ON
AUX
STEREO
3 4
ON ON
PROCESSING
EQ FILT
CMP/ EXP/
DYN
LIM GTE
INS
DLY
OPT
ASN
PAN
SEL
P r o c e s s i n g
USER USER
1 2
3.3.12.2

Delay Parameters

DELAY TIME:

DELAY DISTANCE:
Date printed: 03.09.03
Example: Local Assignment
• Press ASN SEL on the Channel Strip; the ASN SEL key will flash.
The flashing ASN SEL key indicates Select Edit Mode.
• Press DLY on the Channel Strip to control the delay parameters.
EQHI
n–1
TALK
1 2
3 4 LAST MODE
PAGE
FREEZE
The Delay value can only be adjusted as a delay time (displayed in sam-
ples or ms) using the rotary encoder within the fourth LACP section. As
the Delay time is adjusted, the distance display changes to show the corre-
sponding physical distance (displayed in centimeters and meters).
DELAY: Delay can be switched ON/OFF using the DLY key on the Channel Strip.
Delay time can be set in a range from 0 through 47 samples, and from 1 ms
through 100 ms (or, dependent upon the system configuration, to a maxi-
mum of 240 ms). While adjusting delay time, the value is simultaneously
converted into a delay distance (from 0 through 33.3 cm, and from 0.34
through 34 m, or up to 81.5 m, depending on the system configuration).
Both values are displayed simultaneously on the LACP.
Delay distance (display only, no delay distance setting) in cm or m, see
DELAY TIME above.
SW V3.3
EQHI EQHI
n–1 n–1
1 2 TALK 1 2 TALK
3 4 LAST MODE 3 4 LAST MODE
PAGE PAGE
FREEZE FREEZE
D950 Digital Mixing System
EQHI DLAY
n–1 n–1
TALK 1 2 TALK
1 2
3 4 LAST MODE 3 4 LAST MODE
PAGE PAGE
FREEZE
FREEZE
Desk Operation 3-71
EQHI
n–1
1 2 TALK
3 4 LAST MODE
PAGE
FREEZE