6.7.3 Monitoring/Signaling/Talkback Configuration - Studer D950 Operating Instructions Manual

D950 Digital Mixing System

6.7.3 Monitoring/Signaling/Talkback Configuration

HW resources:
[comment]
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!! M O N I T O R I N G
!! This version contains the definition of the special talk-back panel for OA5000
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!
!! FILE NAME: c:\d950system\MonResources.ini
!!
!! This file contains definitions of all cards used in the monitoring (signaling and
!! talk back) system. They are divided in two groups: output cards and input/output
!! cards.
!!
!! 1.2. Card Type Definitions
!! --------------------------
!!
!! 1.2.1. Output Cards
!!
!! A section defining an output card (audio board) has a name of the form: ["CardO_"Type].
!! The section contains some general parameters (OutputStatusLength, NumOfElements)
!! and a specification of each activator on the card.
!! An activator is described by the type (switch or amp), its position in the card
!! status data (byte and bit numbers or byte number and size) and a short name. The
!! activator short name and a specific card name, defined in the section [CARDS], are
!! used for building the activator identification name (e.g. AID_CRIN0_IN2). These names
!! are later used to connect to functions or build groups of activators.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[CardO_SignalOutput]
Type=8
OutputStatusLength=3
NumOfElements=16
!!--------type/offset/pos or size/name!!
0=switch/2/5/REL00
1=switch/2/6/REL01
2=switch/1/0/REL02
3=switch/1/1/REL03
4=switch/1/2/REL04
5=switch/1/3/REL05
6=switch/1/4/REL06
7=switch/1/5/REL07
8=switch/1/6/REL08
9=switch/0/0/REL09
10=switch/0/1/REL10
11=switch/0/2/REL11
12=switch/0/3/REL12
13=switch/0/4/REL13
14=switch/0/5/REL14
15=switch/0/6/REL15
6-18 System Administration
The configuration of the monitoring, signaling, and talkback systems is
done through a set of initialization files.
All hardware resources are defined in the file named
file contains definitions of all control panels and audio cards used by the
monitoring, signaling, and talk back functions. Each component type (card
or panel) is described in detail in this file.
MonResources.ini
D950 monitoring, signaling, and talkback subsystem. The file has to be
available in the folder
and talkback subsystem will not function. A part of the
file is given below with detailed explanations:
R E S O U R C E S L I B R A R Y V 2.0
SW V3.3
is a library of hardware resources that can be used in a
. Otherwise the monitoring, signaling,
C:\D950SYSTEM
. This
MonResources.ini
MonResources.ini
Date printed: 05.12.03