Studer D950 Operating Instructions Manual page 518

D950/Vista7 Digital Mixing System
Glide at End:
Glide at Write Zone End:
Glide at Beginning:
Glide at Punch-In:
Back Time Glide
(applies to End
and Write Zone
5-188 AutoTouch+
When the end time occurs (either in real time or as part of the post proc-
essing) a glide begins. The glide starts at the end time if set to End of Mix
or a Fixed timecode. If the glide takes place during the post process (after
the mix pass is ended) then the Master Glide Button must be active at the
time that the Mix pass is stopped. If End is set to end of time, no glide oc-
curs. (Also see Back Time option below.)
If the Write Zone is active then a glide will occur at the Write Zone End
time either in real time or as part of the post process (subject to the state of
the option and the Master Glide Button. (Also see Back Time option be-
low.)
If the Extend Back To: Begin is active, then a glide will occur at the begin
time (beginning of Mix or a user-input TC) as part of the post processing
(subject to the state of the option and the Master Glide Button)
If the Extend Back To: Punch In is active, then a glide will occur at the
Punch-in time as part of the post processing (subject to the state of the op-
tion and the Master Glide Button at the time of Punch-in).
If this option is set, then the glide will begin such that the glide ENDS at
the End or Write Zone End time rather than beginning at that time. This
back times the glide so the data beyond the end time (or write zone end
End only): time) is perfectly preserved and match BEFORE the transition point.
SW V3.3 Date printed: 27.08.03