Studer D950 Operating Instructions Manual page 429

Channel Patch Operations:
Channel Patch Switches:
Record a Channel Patch Change:
Date printed: 27.08.03
Channel Patch items are operated as follows:
• Input Selector: Place the cursor on or near the Input Selector icon. Each
trackball click will cycle the selector through the inputs. A Touch event
will be produced for each click.
• Processor Block Order: Click and hold the processor block to be
moved, drag it to the new location, and release the trackball button
(click and drag). A Touch event will be produced when the trackball is
released.
• Dynamic Sidechain Link Setup: Clicking Sidechain Link Setup will
open the Sidechain Link window where channels may be added to the
available Sidechain Links. A Touch event will be produced when the
ADD button is clicked.
• Dynamic Sidechain Link Enable: Clicking the Check Box will toggle
the switch state. A Touch event will be produced when the box is
checked or unchecked.
• Dynamic Key Input Routing: The route with the solid line is the current
state. Clicking the dashed line will select that route and a Touch event
will be produced.
• Direct Output Tap Location: The route with the solid line is the current
state. Clicking the dashed line will select that route and a Touch event
will be produced.
• Meter Feed Tap Location: Clicking the alternate location (shown
grayed-out) will select that location and a Touch event will be pro-
duced.
Two Channel Patch items operate as toggle Switches:
• Dynamic Sidechain Link Setup
• Dynamic Sidechain Link Enable
From the Channel Patch, these switches follow the rules of Press and Re-
lease switch operations. However, if these functions are accessed via the
channel strip keys, they may use either Press and Release or Press and
Hold operations. Press and Hold functions are not available via the GC.
As with any control, changes to Channel Patch items may Auditioned.
To automate an item in the Channel Patch, use the following procedure:
1. Select the desired global Control Mode. Write will overwrite previous
changes, both location and connection type.
2. Select TOUCH RECORD.
3. Select the desired "Write To:" and "Extend Back To:" functions.
4. Open the Channel Patch if it is not already open.
5. Perform the desired operation within the Channel Patch.
6. At the time the desired operation is performed, AutoTouch+ will
punch-in. The new item state will persist until the "Write To:" condi-
tions are met or a Global Punch-out occurs.
7. When timecode is stopped, a new Mix Pass will be generated.
SW V3.3
D950/Vista7 Digital Mixing System
AutoTouch+ 5-99