Studer D950 Operating Instructions Manual page 485

Date printed: 27.08.03
[2] Global Pre-Selectors for Control Modes (see also
Before globally any control mode (Read, Write Enable, Trim Enable and
Isolate) can activated, the Pre-Selectors for the desired objects must be ac-
tivated. These are:
FDR (Fader) – all Faders
MUTE – all Mutes
ENC (Encoders) – all continuous controller type encoders (knobs or rota-
ries)
SW (Switches) – all switches
HELD (Held controls) – all controls that are currently in a "Held" state.
This can be any combination of faders, mutes, encoders and switches. Re-
fer to chapter 5.7.3.
CLR / ALL (Clear/All) – Permits the changing of all Pre-Selectors at once.
If one ore more pre-selectors are active, pressing CLR / ALL will clear all
pre-selectors.
If none of the pre-selectors are active, pressing CLR / ALL will activate all
pre-selectors.
If CLR / ALL and a global Mode (e.g. WRITE ENABLE) is pressed, will se-
lect all controls into Write Enable (this is like Pre-Selectors are bypasses).
[3] Automation Indication:
MIX OPEN (green) – Mix is open and automation system is on.
RDY (yellow) – Automation system is ready (e.g. timecode ok).
REC (red) – Automation system is recording.
TOUCH / HELD (see also
[4]
TOUCH RECORD – If activated, touching a write or trim enabled control
element (e.g. fader) will put the touched control into record.
TOUCH HOLD – If activated, touching and releasing a control element (e.g.
fader) will simulate a touch and held the object even manually the control
has been released.
HELD PLAYS MIX – When this key is engaged (see also
Held controls play back their Read Mix data when not in RECORD, but
the controls can be set to different physical positions.
The Read Mix data is heard, even though one or more controls are being
held in AUDITION. This allows a held control to be pre-positioned while
awaiting a punch-in. The result is true emulation of the resultant mix,
while the Mix Pass is being run.
CLEAR HELD – Pressing this key will take all Held controls out of Hold. It
will also clear the list of controls in the Held Controls Buffer.
[5] GLOBAL RECORD (see also
PUNCH IN – Write or Trim Enabled controls are put into record (depending
on the GLOBAL RECORD Pre-Selector setting).
PUNCH OUT – Control elements which are in record are punched out (de-
pending on the GLOBAL RECORD Pre-Selector setting).
SW V3.3
D950/Vista7 Digital Mixing System
chapters 5.7.1 through 5.7.4)
chapter 5.8)
chapter 5.6.5.1)
chapter 5.7.5.1), all
AutoTouch+ 5-155