Studer D950 Operating Instructions Manual page 296

D950/Vista Digital Mixing System
4-100 GC Operation
Show Channels button should be clicked. This will extend the window
as shown below, to allow individual assigning of the channels within
the Session Configuration to the chosen N–1 bus.
The chosen Bus Owner channel is shown in the list as
Any assigned channels to the bus are shown in the list as
Clicking on individual channel boxes will either select or deselect a chan-
nel; this makes the N–1 bus in fact being an N–x bus. It is also possible to
mark a number of channels to be assigned by left-clicking and dragging
across a number of channels for speed.
It is also possible to assign channels to a configured N–1 bus by using the
dedicated bus assignment panel (D950) or bus assign window (Vista) on
the control surface.
The talkback and N–1 bus level control will be displayed in the assigned
channel strip for the N–1 Bus Owner Channel (see
Vista Only: The right-hand bargraph channel meter for the Bus Owner Channel will
automatically show the N–1 bus level output.
F Tip The N–1 settings are stored within snapshots.
SW V3.3
chapter 3.3.3).
Date printed: 05.08.03