Studer D950 Operating Instructions Manual page 351

Static Data Buffer:
Clear Static Button:
Date printed: 27.08.03
This value will be retained in subsequent passes unless the Static value is
changed.
Any time a control is adjusted (without being in RECORD), its Static
value will change. In other words, Static values may be changed as long as
RECORD is not engaged for the control.
Changed Static values are temporarily stored in the "Static Data Buffer."
The next time a new Mix Pass is created (usually by recording a Dynamic
change on another control), the contents of the Static Data Buffer will be
stored in the new pass. The old Static values will be retained in the previ-
ous pass. The new values will be retained in any new Mix Passes made
from the just created pass. The Static Data Buffer may be cleared by
clicking the Clear Static button in the AutoTouch+ window. D950 users
may also use the STATIC key on the Automation Master Panel. In this way,
Static Values may be "Auditioned".
D950:
The Clear Static button in the AutoTouch+ window (and the STATIC DATA
key on the D950 desk AutoTouch+ Panel) has two functions:
• When lit, the Clear Static button indicates there is information in Static
Data Buffer and there is a difference between the current Static values
and those stored within the Active Mix Pass.
• Pressing/clicking the Clear Static button clears the values in the Static
Data Buffer and restores those stored within the Active Mix Pass.
Clearing the Static Data Buffer cannot be undone.
Notes: There is no STATIC key on the Vista work surface.
Static data may also be cleared by clicking the Clear Static button in the
AutoTouch+ window.
SW V3.3
D950/Vista7 Digital Mixing System
AutoTouch+ 5-21