Filters; Dynamics; Panning; Input - Studer D950 Operating Instructions Manual

D950 Digital Mixing System
3.4.3

Filters

3.4.4

Dynamics

3.4.5

Panning

3.4.6

Input

3.4.7

Fader

3.4.8

Outputs

3-118 Desk Operation
Just adjacent to the EQ section are the two full-range (20 Hz to 20 kHz)
high- and low-pass filters. Keys are provided for In/Out and Slope
(12/18/24 dB/oct.) for each band, as well as overall filter set In/Out.
The dynamics section contains a full control set for the four-band dynam-
ics section including Limiter, Compressor, Gate, and Expander. In addi-
tion, controls for the sidechain include HP/LP filters, look-forward,
makeup gain, and side chain keying and linking. Independent In/Out keys
are provided for each dynamics band as well as for the Compres-
sor/Limiter and the Gate/Expander sections.
In the dedicated panning section, three knobs provide Front LCR,
Front/Back, and Rear LCR controls. A fourth knob can be switched
through several modes to provide center feed %, LFE (low-frequency ef-
fect) feed, and divergence control.
The comprehensive input section provides controls for polarity inversion,
stereo mode switching, input selection, and input gain. On those channels
patched to Studer's remote controlled microphone/line pre-amplifiers,
there are dedicated controls for mic/line switching, HPF, mic and line gain,
as well as phantom power on/off. All of this control takes place in the
analog sections of the remote mic/line pre-amps, providing maximum
headroom and digital resolution.
The fader section is a complete duplicate of the fader section within the
normal channel strip. In addition to the precision, long-throw moving
fader, Solo/PFL, Channel On, and Automation switching is provided.
Dedicated Level and On/Off controls are provided for the Direct Output
and the Multitrack or N–1 bus output.
SW V3.3 Date printed: 15.09.03