Studer D950 Operating Instructions Manual page 457

Edit a Mix Pass with OFLA:
At Out Time Functions:
Date printed: 27.08.03
• Trim: Offsets the previously written control values by a fixed amount
within the timecode window. Switches may not be Trimmed.
• Freeze: The control value at the OFLA In time will be retained for the
duration of the timecode window.
• Clear: Controls will be reset to their default values within the timecode
window.
• Make Static: Controls will be made Static. All automation records other
than the Static value will be erased for the entire Mix Pass.
• Spread: Control values at a specific point in a source mix (Active or
Mix Tree) may be applied throughout the timecode window.
• Merge: Control values a timecode window within a source mix (Active
or Mix Tree) may be applied throughout the timecode window.
• Update Snap: Updates the Mix Snapshot. This applies the current con-
trol values from the beginning of the Mix Pass to the first recorded rec-
ord.
Each time an OFLA edit is performed, a new Mix Pass created.
To edit a Mix Pass with OFLA, use the following procedure:
1. Make the Mix Pass to be edited the Active Pass if it is not already.
2. Select "Edit Mix Pass" from the GC Automation menu. The basic Edit
Mix window will open.
3. Click the Select button to open the Object Picker for Edit Object Se-
lector. Using this picker will allow the desired controls on selected
channels to be chosen for editing. Once selected, click either the Ap-
ply button (if more edits will be performed) or the OK button (if no
more objects need to be selected). The controls in the picker will be
selected for editing and will appear in the Selected Objects section of
the Edit Mix window.
4. Select the Edit Type from the Edit Type pull-down menu.
5. Enter the new control value if necessary (depending on Edit Type).
6. Enter the Spread Source Mix or Merge Mix if Spread or Merge edit
types are used. The Mix Passes in the current Mix Tree are available.
7. Enter the timecode locations for edit In and Out points if necessary
(depending on Edit Type).
8. Click on the appropriate radio button to select the "At Out Time"
function. These functions mostly mirror the "Write To" functions
found in AutoTouch+, but have some difference. See below.
9. Click Perform Edit to perform the edit. A new Mix Pass is written
that contains the edited values.
Note: Automated Graphic Controller items are not selectable using the Object
Picker for Edit Object Selector.
The select "At Out Time" function will determine how the edit data transi-
tions back to Read Mix data.
At Out Time selections function as follows:
• Restore Values: This is the equivalent to "Write To: Punch-Out". Read
Mix control values will be restored at the OFLA Out Time. Glide func-
tions are not available.
• Write to End: This is the equivalent to "Write To: End" except the edit
control values will be written to the end of the Mix Pass. To use a fixed
end time select Restore Values as the At Out Time function. "Write To:
End Of Time" is not available.
• Write to Next Change: This is the equivalent to "Write To: Next
Change". Read Mix control values will be restored when the next rec-
ord is encountered. Glide functions are not available.
SW V3.3
D950/Vista7 Digital Mixing System
AutoTouch+ 5-127