Studer D950 Operating Instructions Manual page 492

D950/Vista7 Digital Mixing System
Mode Selection:
Affected Controls:
Other Functions:
5-162 AutoTouch+
Consecutive presses will select the next available Control Mode for that
channel <Option>. Which Control Modes are included and the order in
which they appear in the cycle is determined by Options selected in the
Control Modes Options page (also refer to
The channel controls affected by the chosen Control Mode are determined
by the settings on the Control Modes Options page. The following Channel
Auto-Mode Affects... options may be selected:
• <Pre-Selector Objects>: The controls selected in the global Control
Mode Pre-Selectors.
• <Fader>: Fader only
• <Mute>: Mute only
• <Fader and Mute>: Fader and Mute only
The current Control Mode for the fader is indicated to its right.
When held down, the AUTO / MODE key serves two additional purposes:
• Punch-In/Out Key for selected encoders and switches: When holding
down the AUTO / MODE key and actuating an encoder or switch, indi-
vidual controls within the channel strip may be punched in or out of
RECORD. This assumes the controls are properly enabled.
• Modifier Key: When held down, the key:
- Prevents switches from toggling states
- Inverts the Touch and possibly the Un-touch functions <Option>
for Touch Record and Touch Hold.
Options for the AUTO / MODE key are set in the Channel Auto-Mode But-
<Option>
ton section of the Control Modes Option page (also refer to
5.21.2):
• <Order>: There are four positions that can be accessed via consecutive
presses of the AUTO / MODE key.
- The assignment for each position is made using the four pull-down
menus in the <Order> section.
- The top menu represents the first position.
- Any Control Mode can be selected at any position or none can be
selected.
- If <None> is selected, that position is not included when cycling
the AUTO / MODE key.
• <Affects...>: The selection of controls that enter the selected Control
Mode is determined in the <Affects...> section. Radio buttons allow
the selection of one of the following options:
- <Pre-Selector Objects>: Local controls that correspond to the active
Control Mode Pre-Selectors on the AutoTouch+ Panel.
- <Fader>: Fader only
- <Mute>: Mute only
- <Fader & Mute>: Fader and Mute only
• Either the <Touch Hold> or <Touch Record> function may be selected
for Modified Un-touch Inversion when the AUTO / MODE key is held.
This selection is made by clicking the desired radio button in the
<Modified Un-touch Inverts> section of the Misc Options page (refer to
chapter
SW V3.3
5.21.8).
chapter 5.21.2).
Date printed: 27.08.03
chapter