Studer D950 Operating Instructions Manual page 543

300000 = Unable to communicate with UPS
300100 = UPS output overload
300200 = UPS self-test failed
300201 = Scheduled UPS self-test failed: Bad battery
300202 = Scheduled UPS self-test failed: Invalid test
300203 = User initiated self-test failed: Bad battery
300204 = User initiated self-test failed: Invalid test
300205 = Self-test at UPS failed: Bad battery
300206 = Self-test at UPS failed: Invalid test
300300 = UPS battery is discharged
300301 = UPS battery is discharged: #BATTERY_CAPACITY#
300400 = Communication lost while on battery
300600 = Contact #CONTACT_NUMBER# fault (#CONTACT_POSITION#): #USER_COMMENT#
301000 = Check installation of Smart Cell signal cable
301300 = UPS on bypass: internal temp over limit
301301 = UPS on bypass: battery charger failure
301302 = UPS on bypass: severe DC imbalance overload
301303 = UPS on bypass: output voltage outside limits
301304 = UPS on bypass: top module fan needs repair
301400 = Base module fan needs repair
301500 = Base module bypass power supply needs repair
301600 = UPS battery needs replacing
310001 = Below lower ambient temperature threshold of #LOW_THRESHOLD#
310002 = Exceeded upper ambient temperature threshold of #HIGH_THRESHOLD#
310101 = Below humidity threshold of #LOW_THRESHOLD#
310102 = Exceeded upper humidity threshold of #HIGH_THRESHOLD#
[ PopupText ]
1003 = Normal utility power at #HOSTNAME# has been restored.
1006 = Shutdown of #HOSTNAME# has been cancelled.
1007 = UPS batteries at #HOSTNAME# are no longer discharged.
1016 = Shutdown process started.
2000 = #HOSTNAME# is running on battery power.
2001 = #HOSTNAME# has been shutdown.
2003 = Low battery power at #HOSTNAME#.
3000 = #HOSTNAME# has lost communications with the UPS.
3003 = UPS batteries at #HOSTNAME# are discharged.
[FlexEventNames]
1000=PowerChute Started
1001=PowerChute Stopped
1002=Communication Established
1003=Utility Power Restored
1004=UPS Self-Test Passed
1005=Administrative Shutdown
1006=Shutdown Cancelled
1007=Return From Low Battery
1009=UPS Battery Replaced
1010=Contact Normal
1013=Overload Condition Solved
1014=Run Time Calibration Started
1015=Run Time Calibration Finished
1016=System Shutdown Starting
1017=UPS Return From Bypass
1018=Smart Cell signal returned
1100=Ambient Temp In Range
1101=Humidity In Range
2000=UPS On Battery
2001=System Shutdown Complete
2002=UPS Enabling Smart Boost
2003=Low Battery Condition
2004=Run Time Calibration Aborted
2013=UPS On Bypass: Maintenance
Date printed: 05.12.03 SW V3.3
D950 Digital Mixing System
System Administration 6-13