Studer D950 Operating Instructions Manual page 496

D950/Vista7 Digital Mixing System
D950 Classic:
When displaying values, this shows the
value according to the mode charts; when
the control is in TRIM it shows the offset
and direction from the trim null point.
Always shows the current knob position.
Lights when any S/E is in TRIM or WRITE
ENABLE. Flashes when any S/E is in
RECORD.
• Pressing punches all S/E into Playback.
• Pressing with AUTO MODE held down
punches all objects into Playback.
• Pressing twice puts all enabled S/Es
into RECORD or only enabled S/Es that
are touched or held (basing on GC
option).
Control Modes:
S/E PB, S/E REC Key:
Single Press Functions:
Double-Press Functions:
Status Indication:
5-166 AutoTouch+
The switches and encoders Control Mode may be selected locally by
pressing the AUTO MODE key. Repeated pressed will cycle the available
controls modes <Option>. See paragraph "Auto Mode" above.
The Switches/Encoders Playback (S/E PB), Switches/Encoders Record (S/E
REC) key is the primary control for automating channel switches and en-
coders.
• A single press will punch-out any switch and/or encoder that is in
RECORD.
• A single press while holding down the AUTO MODE key will punch-out
all objects that are in RECORD.
• Double-pressing puts any enabled switch and/or encoder that is
Touched or Held into RECORD.
S/E PB, S/E REC key provides information about the automation status of
the channel's switches and encoders:
• Continuously on: One or more switch and/or encoder is in WRITE or
TRIM enable.
• Flashing: One or more switch and/or encoder is in RECORD.
Each encoder has its own Control Mode indicator LED:
• Off: READ or ISOLATE
• Continuously, red: WRITE ENABLE
• Flashing, red: WRITE RECORD
• Continuously, green: TRIM ENABLE
• Flashing, green: TRIM RECORD
SW V3.3
Off = READ or ISOLATE
Cont. red = Absolute ENABLE
Flashing red = Absolute RECORD
Cont. green = TRIM ENABLE
Flashing green = TRIM RECORD
For the last knob touched... Always shows
the difference between the fader value and
the effective READ value. An exception is to
show the offset from the TRIM null point
when in TRIM mode (this is always the
absolute position of the fader from 0 dB.
When the Fader is in TRIM this shows the
offset and direction from the TRIM null
point. When a RECORD waiting event is
active (punch-out in AT), shows the
difference and direction to the match point
(the effective READ data).
Date printed: 27.08.03