Gc Menu Items - Studer D950 Operating Instructions Manual

D950/Vista7 Digital Mixing System
Record Recalled VMC Values:
5.12.3

GC Menu Items

Automatable Option Menu Items: The following Option menu items contain automatable controls:
Menu Item Behavior:
5-102 AutoTouch+
Since values are being applied to VMC controls, the affects of recalling
Snapshots or Presets may Auditioned.
To record Snapshot or Preset values to controls, use the following proce-
dure:
1. Select the desired global Control Mode.
2. Select TOUCH RECORD.
3. Select the desired "Write To:" function (Trim will default to "Next
Change").
4. Open the Snapshot page in the GC if it is not already open.
5. Recall the desired Snapshot or Preset.
6. Global conditions will apply to the controls that were enabled.
7. When timecode is stopped, a new Mix Pass will be generated.
Note: Recalling the channel strip clipboard has the same affect as recalling a
Snapshot or Preset, except values are only applied on one channel at a
time. Recording recalled clipboard values may be done as described above.
Some operational GC menu items may be automated. During normal op-
eration, these items are found in the GC Option menu. However, since all
VMC objects are available in the ShowVMCTree menu (In the SysAdmin
menu), these menu items may be automated as well.
• Meter/Generator: Global channel Meter locations and Generator pa-
rameters may be automated. Changes made to these items will produce
Touch/Un-touch events.
• N–1 Assignments: N–1 Assignments may automated. Changes made to
these assignments will produce Touch/Un-touch events.
• Control Group Filter: Changes made within each Control Group may be
automated. Changes made within a Control Group will produce
Touch/Un-touch events.
• VSP Microphones and Reverb: Changes made Reverb Bus Assignments
and Microphone Characteristics (polar pattern and placement) may be
automated. Changes made within the VSP Microphones and Reverb
menu items will produce Touch/Un-touch events.
The GC menus do not have dedicated automation controls. The current
global automation modes apply to the automatable GC menu items. For an
Option menu item use either the SW (SWIT) or ENC (KNOB) Pre-
Selectors to select global modes, depending on item to be automated. For
"ShowVMCTree" items, any Pre-Selector may be used, depending on the
controls/functions the user wishes to enable.
Menu item switches and selectors will follow the rules of a Press and Re-
lease switch operation, refer to
and "Extend Back To:" conditions apply.
SW V3.3
chapter 5.10.3.1. All Mix Pass "Write To:"
Date printed: 27.08.03