Write Zones - Studer D950 Operating Instructions Manual

5.1.5

Write Zones

Date printed: 27.08.03
5 Locate the end point 1:00:09:20 using the jog wheel (the user can freely
jog around this point and even overshoot in order to locate precisely). It
is possible to use locate commands as well.
6 Deactivate TC OFF (Vista) or SUSPEND (D950). ⇒ Automation data is
written up to the current timecode value.
7 Finish the mix pass by switching STOP FRAME off.
In order to protect any passages from being overwritten by automation
data, it is possible to define a write zone in the graphical controller. If acti-
vated, it is not possible to write any data outside that zone. When working
together with machine control (looping), it is possible to synchronize this
write zone constantly with the set In and Out points of the machine con-
trol.
SW V3.3
D950/Vista7 Digital Mixing System
AutoTouch+ 5-11