Option: Tc Reader / Gen - Studer D950 Operating Instructions Manual

Generator/Level:
Generator/Frequency:
Generator/Signal:
Generator/Defaults:
4.6.5.2

Option: TC Reader / Gen.

TC2 Setup Window:
Date printed: 05.08.03
This action sets the test signal generator's level to the desired value. Lev-
els can be set to off and, in 1 dB steps, from –90 to +10 dB
erator Level can be turned off by moving the Level slider all the way to the
left.
This action sets the test signal generator's frequency (sine wave only) to
the desired value. The generator frequency can be set in 1/12
from 19.95 Hz to 19.95 kHz.
This action selects the waveform of the test signal generator, from Sine
Wave, White Noise, and Pink Noise.
This action sets the test signal Generator's level and frequency defaults by
using the arrow buttons to adjust the default values.
To quickly apply a level or frequency default, rather than to adjust it
manually, click on the appropriate Defaults button. Default levels can be
set in 1 dB steps, from –90 to +10 dB
turned off from the Defaults controls. Default frequencies can be set in
th
1/12 octave steps from 19.95 Hz to 19.95 kHz.
F Tip
By default, the Test Signal Generator is patched to GEN (third channel
input) of all channels. It also appears as a signal source in the General
Patch and can be patched to any target from there.
The TC (Timecode) Reader/Generator Setup page is only available in two
cases:
• If the full AutoTouch+ Dynamic Automation system is installed, or
• If the TC2 or TC3 Reader/Generator option is installed.
SW V3.3
D950/Vista Digital Mixing System
. The Generator Level cannot be
FS
GC Operation 4-95
. The Gen-
FS
th
octave steps