Auto Punch-In/Out; Auto Gpi In/Out - Studer D950 Operating Instructions Manual

D950/Vista7 Digital Mixing System
5.8.4

Auto Punch-In/Out

Write Zone:
Auto Punch-in:
Performing the Punch:
5.8.5

Auto GPI In/Out

5-78 AutoTouch+
Automatic punch-in/punch-out is controlled via the AutoTouch+ screen of
the D950 GC.
To set up an Auto Punch-in/Out, a "Write Zone" with a "Begin" and
"End" time must first be established. These will be the In and Out point for
the Auto Punch-in. The times displayed were the last In and Out times
used by the system. Direct entry of Begin and End times is possible once
the Write Zone is enabled. Refer to
To activate the Auto Punch-in feature, the Write Zone must first be en-
abled, which is done by checking the "Enable" box next to the End time
field. Once the Write Zone is enabled, it is then possible to enable the
Auto Punch-in facility. This is accomplished by checking the "Auto Punch
In" box located below the Write Zone Enable box.
Once Auto Punch-In is enabled and the desired controls are enabled, play
back timecode (media). During the pre-roll before the Begin Time, the af-
fected controls will act as if in RECORD ENABLE, but will not punch-in
until the Write Zone Begin time.
At the Begin time, the system will automatically punch-in and the any
enabled controls will change to RECORD. Recording will continue until
the End time is reached, where the controls are automatically punched out.
Note: It is possible to punch-out any individual control at any time within the
Write Zone using the AUTO MODE key. Global punch-outs may also take
place before the end of the Write zone. It is not possible to punch-in before
the Begin time or after the End time when the Write Zone is enabled.
Note: Glide functions may be used with Auto Punch-In/Out. Since changes to the
Read Mix are prohibited after the Write Zone End time, the Backtime
Glide function must be used if Auto Punch-out is used.
Global Punch-Ins and Punch-Outs can also be done via the GPI input. This
will basically make the Punch-In and Punch-Out key available to external
systems or external keys.
If such functionality is required, the
adapted accordingly. Please contact Studer Service & Support to do the
necessary changes in that file.
SW V3.3
chapter 5.8.3 for details.
file needs to be
Signaling.ini
Date printed: 27.08.03