D950 Channel Strip Switch And Encoder Controls - Studer D950 Operating Instructions Manual

5.19.1.1.4

D950 Channel Strip Switch and Encoder Controls

LACP Controls:
D950 M2:
Date printed: 27.08.03
The four touch-sensitive rotary encoders and their associated switches
provide primary parameter control for channel audio processes. The Input
Selector, processor block in/out keys, and the first four mono and stereo
AUX in/out keys are also automatable.
The ASN SEL (ASN ENC on D950 M2), USER1, USER2, PAGE, TALK, L1,
L2, and LAST / FREEZE keys are not automatable.
These keys are fully automated. When
enabled, and Touch Record is active,
pressing a key toggles the status of the
function and punches it into Record. If
Touch Record is not active, pressing this
key just toggles its status.
If the AUTO / MODE key is held, pressing
a key punches that function in (if
enabled) or out (if recording) of
Automation Record.
Press and Hold: If a switch is held, its
release will cause a punch-out, if it was in
Record prior to its release.
Keys not affected by the Automation
System.
Encoder Automation Mode LEDs:
Off = Read or Isolate
Continuous, red = Absolute Enable
Flashing, red = Absolute Record
Continuous, green = Trim Enable
Flashing, green = Trim Record
Null LEDs - for the last knob touched:
Always show the difference between the
fader value and the effective read value.
An exception is to show the offset from
the Trim Null point when in Trim mode
(this is always the absolute position of
the fader from 0 dB).
Keys not affected by the Automation
System.
SW V3.3
D950/Vista7 Digital Mixing System
AutoTouch+ 5-165