Local Mode Entry - Studer D950 Operating Instructions Manual

5.6.5.2

Local Mode Entry

Local Control Mode Entry:
Date printed: 27.08.03
The AUTO / AUTO MODE key on the channel strip can be used to enter the
various Control Modes on a channel-by-channel basis.
D950:
Pressing the AUTO / AUTO MODE key will cycle through the available
Control Modes. The order and availability of Control Modes that can be
entered is determined by the options selected in the Channel Auto-Mode
Button section of the Control Modes Options page. The selection of local
controls that enter the selected Control Mode is also determined at this lo-
cation.
Options for the AUTO / AUTO MODE key are set in the Channel Auto-Mode
<Option>
Button section of the Control Modes Option page (also refer to
5.21.2):
• <Order>: There are 4 positions that can be accessed via consecutive
presses of the AUTO / AUTO MODE key.
- The assignment for each position is made using the four pull-down
menus in the <Order> section.
- The top menu represents the first position.
- Any Control Mode can be selected at any position or none can be
selected.
- If <None> is selected, that position is not included when cycling
the AUTO / AUTO MODE key.
• <Affects...>: The selection of controls that enter the selected Control
Mode is determined in the <Affects...> section. Radio buttons allow
the selection of 1 of the following options:
- <Pre-Selector Objects>: Local controls that correspond to the active
Control Mode Pre-Selectors on the Master Automation Panel.
- <Fader>: Fader only
- <Mute>: Mute only
- <Fader & Mute>: Fader and Mute only.
SW V3.3
D950/Vista7 Digital Mixing System
Vista:
AutoTouch+ 5-53
chapter