Studer D950 Operating Instructions Manual page 508

D950/Vista7 Digital Mixing System
5-178 AutoTouch+
[6] Extend Back to / Write to.
In the entry box "Extend Back To:" a Fixed value, the Beginning of Time,
or the Beginning of the Mix can be selected. In the entry box "Write To:" a
Fixed value, the End of Time or the End of Mix can be defined.
If "Fixed" has been selected, an timecode entry box will be opened. Use
the same method to enter a timecode as explained under point [4].
"Extend Back To:" can be activated on the AutoTouch+ panel. Either Ex-
tend back to BEGIN or PUNCH IN can be selected.
Refer to chapter 5.9.2
Selected "Extend Back To:" BEGIN (on the AutoTouch+ panel) will be
displayed in the GC Auto Touch Plus panel in red, to indicate that this
function has been activated.
This means that automated parameters will be written back to the selected
timecode value (fixed, beginning of time, or beginning of mix) in the next
mix pass.
A green indication refers to activated "Extend Back To: PUNCH IN".
The entered timecode value (fixed, beginning of time or beginning of mix)
is not activated.
That means that automated parameters will be written back to PUNCH IN
time in the next mix pass.
Write to: is red and active if WRITE TO: END on the AutoTouch+ panel has
been selected (also refer to
Green indicates that Extend Back to: PUNCH IN will be performed and
the red Write to: shows, that "Write to: END will be performed.
SW V3.3
for more information on "Extend Back To:".
chapter 5.9.1).
Date printed: 27.08.03