Write - Studer D950 Operating Instructions Manual

D950/Vista7 Digital Mixing System
5.6.2

Write

WRITE Rules:
D950 Null Indications
Rotary Null Indicators:
Fader Null Indicators:
5-44 AutoTouch+
WRITE is the primary data recording mode of the system. Controls in
WRITE ENABLE are armed for recording and those in WRITE RECORD will
write changes to a new Mix Pass.
Record Off:
• WRITE ENABLE: The control acts the same as if it were in READ (re-
playing the mix Read data), but is armed to go into WRITE RECORD.
- A new Mix Pass is not generated unless RECORD is engaged.
Record On:
• WRITE RECORD: The absolute value (level) of the control is written into
a new Mix Pass.
- Read mix values are overwritten.
At the end of a pass in which at least one control was in WRITE
-
RECORD, a new Mix Pass is generated based upon the Active Mix
Pass and the newly recorded data.
WRITE RECORD is a destructive mode in regard that previously written data
Note:
is overwritten. However, mix data is never lost because a new Mix Pass is
generated at the end of every RECORD pass. All Mix Passes are retained in
the Mix Tree unless purposely deleted.
When a control is being written, a Null indication is provided. In basic
terms, the null indication provides information regarding the difference
between the current value of a control and its Read Mix value.
Write mode null indications are handled the same for faders and encoders,
however null indications are given only for the last encoder used.
SW V3.3
For the last knob touched... Always shows the
difference between the rotary value and the effective
read value. En exception is to show the offset form the
trim null point when in TRIM mode (this is always the
absolute position of the rotary from 0 dB or the center
value).
Always shows the difference between the fader value
and the effective read value. En exception is to show
the offset form the trim null point when in TRIM mode
(this is always the absolute position of the fader from
0 dB).
Date printed: 27.08.03