Insert Section; Assigning The Insert Section - Studer D950 Operating Instructions Manual

D950 Digital Mixing System
3.3.11

Insert Section

INPUT DIR OUT
IN 1 Input Out ON
IN 2
Busses
GEN
Meters
1 2
ON ON
AUX
MONO
3 4
ON ON
1 2
ON ON
AUX
STEREO
3 4
ON ON
PROCESSING
EQ FILT
CMP/ EXP/
DYN
LIM GTE
INS
3.3.11.1

Assigning the Insert Section

OUT/
INPUT
N-1
EQ FILTER
EQ2
LIM/ EXP/
COMP GATE
INSERT DELAY
MONO ADD.
AUX AUX
STEREO
PAN
AUX
PAGE PAGE
1 2
PAGE PAGE
3 4
AUTO
SHOW
ASSIGN
VALUES
MODES
FREEZE LINK
OFF ACCESS
MENU
3-66 Desk Operation
Insert points are available for all channels. Adjustable parameters are:
• INS ON/OFF (same function as the INS key on the Channel Strip),
• MIX function ON/OFF,
• MIX percentage level setting (send-to-return ratio).
Note: Pressing the INS key can interrupt the signal path if no signal is connected
to the Insert Return.
A. Global Assignment:
• Press INSERT on the Master Menu Selector.
The displays of all Channel Strips will switch over and indicate the in-
sert control parameters, except those in FREEZE mode; see
3.3.2.
• PAGE 1 is the only page available.
B. Local Assignment on the Channel Strip:
• Press ASN SEL; the ASN SEL key will flash.
• Press the INS key. The Insert parameters will be displayed on the
LACP
(= PAGE 1 only)
C. Local Assignment affecting all channel strips:
• Press LINK ACCESS on the Master Menu Selector.
• Pressing a local assignment key will now affect all Channel Strips. The
same functions as described in "B" are available.
D. Local Assignment with Auto Assign Modes "In-Only":
• Press AUTO ASSIGN MODES on the Master Menu Selector once
(AUTO ASSIGN MODES is illuminated).
• Pressing the INS key on the channel strip will assign the Insert pa-
rameters to the LACP without pressing the ASN SEL key, provided
the function toggles to an IN (or ON) status. If it toggles to an OUT (or
OFF) status, the knob status does not change.
SW V3.3
chapter
Date printed: 03.09.03