Studer D950 Operating Instructions Manual page 486

D950/Vista7 Digital Mixing System
5-156 AutoTouch+
Global Pre-Selectors for GLOBAL RECORD (see also
[6]
Before globally any control can be punched In or punched out (Record,
Play), the Pre-Selectors for the desired objects must be activated. These
are:
FDR (Fader) – all Faders
MUTE – all Mutes
ENC (Encoders) – all continuous controller type encoders (knobs or rota-
ries)
SW (Switches) – all switches
HELD (Held controls) – all controls that are currently in a "Held" state.
This can be any combination of faders, mutes, encoders and switches. Re-
fer to chapter 5.7.3.
CLR / ALL (Clear/All) – Permits the changing of all Pre-Selectors at once.
If one ore more pre-selectors are active, pressing CLR / ALL will clear all
pre-selectors.
If none of the pre-selectors are active, pressing CLR / ALL will activate all
pre-selectors.
Holding CLR / ALL and pressing a Global Record command (Punch-in or
Punch-out) will affect all controls (like Pre-Selectors are bypassed).
MIX PASS WRITE TO: (also refer to
[7]
WRITE TO: LEVEL MATCH, NEXT CHANGE, END will write the value at the
time of punch-out further ahead, rather than immediately stop recording.
The neutral default setting is PUNCH OUT. This will record no more after
punch-out.
WRITE TO: PUNCH OUT – The automation system stays in record until
Punch-out is performed.
WRITE TO: NEXT CHANGE – The last recorded data will be applied until the
next recorded change in the Read Mix data. At that point the automation
will transition from record data to read mix data.
WRITE TO: LEVEL MATCH – The last recorded value will be written until it
matches the read mix data.
WRITE TO: END – The Last Recorded Value will be applied until the user-
specified End Time. All previously recorded values between the Last Re-
corded Value (typically Punch-out) and the End Time will be erased.
[8] MIX PASS EXTEND BACK TO: (see also
EXTEND BACK TO: PUNCH IN – Extend the Last Recorded Value back to
the punch-in location.
EXTEND BACK TO: BEGIN – Extend the Last Recorded Value back to the
specified Begin Time.
[9] Mix Pass WITH: GLIDE (see also
WITH: GLIDE – Activates the Glide function.
[10] STOP FRAME (see also
STOP FRAME ON – Activates the stop frame automation.
STOP FRAME SUSPEND – Stop Frame recording is suspended. This allows
timecode to be moved backward or forward so a timecode location may be
found. No control values will be written while Suspend is engaged.
SW V3.3
chapter 5.9.1).
chapter
chapter 5.9.3).
chapter 5.15).
chapter 5.8.1).
5.9.2).
Date printed: 27.08.03