Switch Control Modes - Studer D950 Operating Instructions Manual

D950/Vista7 Digital Mixing System
5.10.2

Switch Control Modes

5-90 AutoTouch+
In Process Listen Keys: INPUT LISTEN, SC/DYN LISTEN, EQ LISTEN,
-
INSERT LISTEN
User Keys: USER 1
-
Note: While clipboard functions are not automatable, the affects of their use may
affect control values. Because of this, the results of clipboard operations
may be recorded as automation events.
Selectors: Selectors are a special group of controls that typically use the encoder
knobs as a means of physical control, but function as "switches" within
AutoTouch+. This differs from switches that operate as "toggles," and al-
ternate between two states.
Selectors perform one of two functions:
• Audio Routing: Input Selector, Direct Out tap location, Meter tap loca-
tion, Processor Block Order, etc.
• Processor Parameter Selector: Input Function, Filter Slope, etc.
Selectors may be assigned to switches, knobs, or to the Channel Patch for a
means of control. However, they may only be pre-selected using the SW
(SWIT) Pre-Selectors.
Note: The Channel Input Selector is a special case in regard that it has a key for
each input on the channel strip. However, these keys function collectively
as a Selector. The input may also be selected from the Channel Patch.
Note: Press and Hold operations may not apply to all selectors.
Since switches and selectors are not continuous controllers like faders or
encoders, Control Modes affect switches in a unique manner.
Switch operations will perform the following functions when dynamic
switches are in the Control Modes indicated:
READ: The Read Mix data will determine the switch state. AUDITION mode is
available.
• Press and Release Actuation:
- Without Touch Hold engaged, Switch Press will toggle the switch
state and put the switch in Audition. The switch state will toggle
back at the next recorded change of state.
- With Touch Hold engaged, Switch Press will toggle the switch state
and put the switch in Audition in a Held state. The switch will hold
its alternate state and stay in Audition until Held controls are
cleared.
• Press and Hold Actuation:
- Switch Press will toggle the switch state and put the switch in
Audition. The switch will exit Audition when released. If its state
does not match the Read Mix state, it will toggle to match upon re-
lease.
SW V3.3 Date printed: 27.08.03