Input Section - Studer D950 Operating Instructions Manual

3.3.3

Input Section

INPUT DIR OUT
IN 1 ON
Input Out
IN 2
Busses
GEN
Meters
1 2
ON ON
AUX
MONO
3 4
ON ON
1 2
ON ON
AUX
STEREO
3 4
ON ON
PROCESSING
EQ FILT
CMP/ EXP/
DYN
LIM GTE
INS
DLY
OPT
ASN
PAN
SEL
P r o c e s s i n g
USER USER
1 2
Date printed: 03.09.03
mode on the Master Menu Selector or from being changed by the LINK
ACCESS function. Local LACP selection, however, is still available. A
subsequent double clicking of the LAST MODE / ••FREEZE key deacti-
vates that channel strip's FREEZE mode. Pressing the FREEZE OFF key
on the Master Menu Selector deactivates the FREEZE function on a global
basis.
Every input/output module features three input selectors:
IN 1: Input 1 (access via internal switching matrix)
IN 2: Input 2 (access via internal switching matrix)
GEN: Generator (default mode) or Input 3 (access via internal switching matrix).
IN 1 / IN 2 If one of these inputs has been selected, the signal source connected to the
channel via the internal switching matrix (General Patch) will be routed to
the DSP channel.
GEN If this input has been selected, the signal source connected to the channel
via the internal switching matrix (labeled as Channel In3 in the General
Patch) will be routed to the DSP channel.
By default, the generator signal is connected to this input. Any other signal
can be connected using the internal switching matrix, as is the case for
IN 1 and IN 2.
Notes: IN 1, IN 2, and GEN inputs can also be selected on Master, Group and
AUX output channels; however, IN 1 then defaults to the corresponding
bus source.
LACP Input parameters are only available for channels that have been
configured with the "INPUT HPF/LPF & GAIN" function. However, all
channels must be configured with Input Selectors. Refer to
for details.
SW V3.3
D950 Digital Mixing System
chapter 7.4.3.1
Desk Operation 3-13