How To Use Vista Strip Setup; Assigning A Single Dsp Channel To A Single Channel Strip; Assigning Multiple Channels In One Single Action - Studer D950 Operating Instructions Manual

D950/Vista Digital Mixing System
4.4.7.1

How to Use Vista Strip Setup

4.4.7.1.1

Assigning a Single DSP Channel to a Single Channel Strip

4.4.7.1.2

Assigning Multiple Channels in one Single Action

4-70 GC Operation
To create a new strip setup or to adapt an existing strip setup, first call up
the strip setup page (see above).
To assign a channel to one of the virtual channel strips, right-click on the
virtual channel strip that the DSP channel is to be displayed on. This will
highlight the chosen channel and a selection menu will appear, listing all
the categories of channel types. These are submenus that contain a list of
the available DSP channels in the loaded Session Configuration. Move the
cursor to the drop-down menu of the desired channel type and select the
desired channel from the list to assign it to the highlighted channel strip.
It is possible to assign consecutive DSP channels onto consecutive channel
strips in one action. First use the hold and drag function of windows to se-
lect a number of consecutive channel strips. This will highlight the se-
lected channel strips. Right-click on any of the highlighted channels to
open the channel selector menus. Select the first channel of the consecu-
tive channels to be assigned. Consecutive DSP Channels will now be
pasted to fill the number of highlighted strips.
F Tip By double-clicking on a single channel, the complete bay of 10 strips that
the channel strip resides is selected. Three clicks on a single channel will
select all channel strips within the complete Section.
SW V3.3 Date printed: 05.08.03