9.4
Regular Maintenance
9.4.1
Air Filters
9.4.1.1
Removing and Installing the Supply Unit (1.950.601.00) in the Rack
Removing:
Installation:
9.4.1.2
Changing the Air Filter Mat
Date printed: 03.09.03
•
Before you start set the DC OUTPUT switch to OFF, also switch off the
mains supply whenever possible.
•
Loosen the four knurled screws at the front panel; pull out the supply unit
towards the front.
•
Carefully insert the supply unit into the rack.
•
Never apply sheer force if the connector contacts do not find their way
easily; check the path to the female contact points inside the rack, it might
be blocked by a foreign object.
•
Retighten the four knurled screws at the front panel.
DC
OK
DC OUTPUT
ON
OFF
•
Remove the supply unit as described above.
•
Place the supply unit onto your working surface in a way that the front
panel is directed towards you.
•
The wire bracket which fixes the filter mat is hooked into four recesses;
first unhook at the upper right, then at the upper left.
•
Now the filter mat can be pulled out in upward direction.
•
For inserting the new filter mat tilt the supply unit to the left. Carefully lift
the lower part of the wire bracket by a small amount with an appropriate
tool (e.g. screwdriver); slide the new filter mat in under the bracket. Make
sure that all the air vents are covered by the filter mat and readjust it, if
necessary.
•
Bring the supply unit in an upright position again and hook the wire
bracket first at the left, then at the right-hand side.
•
Recheck that all the air vents are covered by the filter mat.
•
Reinstall the supply unit as described above.
SW V3.3
D950 Digital Mixing System
Troubleshooting/Maintenance 9-11
Filter mat
Wire bracket
Front panel,
front view