Input Parameters - Studer D950 Operating Instructions Manual

D950 Digital Mixing System
3.3.3.2

Input Parameters

MONO INPUT
Page
1 2
Parameters IN1 IN2
PHASE
X X
XY/MS-MODE – –
INPUT MODE
– –
INPUT GAIN X X
DC REJECT
X X
XY/MS MODE:
3-16 Desk Operation
For input sources IN 1, IN 2, and GEN, an input control section is avail-
able. The number of functions available on Input/Output channels, as well
as on Mono or Stereo channels, depends on the active configuration.
For IN/OUT channels, the following parameters are available:
STEREO INPUT
3 1 2 3
GEN IN1 IN2 GEN IN1
X X X X
– X X –
– X X –
X X X X
X X X X
PHASE: On MONO channels, two positions are provided:
• NORM, in phase (default setting).
• REV, out-of-phase.
On STEREO channels, four different positions are provided:
• NORM, in phase (default setting).
• PH 1, left channel or input A out-of-phase.
• PH 2, right channel or input B out-of-phase.
• PH12, left and right channels or inputs A and B out-of-phase.
Input source
Right
On STEREO channels only.
• XY, (default setting), for coincident XY stereo microphone setups.
• MS, (Mid/Side information), used for decoding MS information from
appropriate coincident stereo-microphone arrays.
SW V3.3
MONO GROUP STEREO GROUP
1 2 3 1 2
IN2 GEN IN1 IN2
X X X X X
– – – X X
– – – X X
X X X X X
X X X X X
A
Left
Phase
Matrix
B
Stereo channel
MONO/STEREO
MONO/STEREO AUX
MASTER
3 1 2 3
GEN IN1 IN2 GEN IN1
X – – –
– – – –
– – – –
X – – –
X – – –
X = A
Normal:
Y = B
X
X = –A
Phase 1:
Y = B
Y
X = A
Phase 2:
Y = –B
X = –A
Phase 1+2:
Y = –B
Date printed: 03.09.03
1 2 3
IN2 GEN
– – –
– – –
– – –
– – –
– – –