Input/Output Unit - Studer D950 Operating Instructions Manual

D950 Digital Mixing System
2.5.3

Input/Output Unit

INPUT DIR OUT
IN 1 ON
Input Out
IN 2
Busses
GEN
Meters
1 2
ON ON
AUX
MONO
3 4
ON ON
1 2
ON ON
AUX
STEREO
3 4
ON ON
PROCESSING
EQ
FILT
CMP/ EXP/
DYN
LIM GTE
INS
DLY
OPT
ASN
PAN
SEL
P r o c e s s i n g
USER USER
1 2
1
SW
AUTO
2
SW
AUTO
3
SW
AUTO
4
SW
AUTO
n–1
1 2 TALK
3 4 LAST MODE
PAGE
•• FREEZE
2-24 Getting started
The Input/Output Unit provides a detailed display of and access to Chan-
nel Functions, and is used in conjunction with the Fader Unit. It is de-
signed as a "four-channel" unit with four identical input/output strips inte-
grated into a single module. Dimensions: 162.5 × 420 mm; the drawing left
shows just a one-channel portion of the unit.
Because of the D950's free configurability, it can happen that certain
functions (EQ, Dynamics, etc.) have not been configured for a particular
channel. In such cases, the controls listed below will not be active and will
not illuminate.
The Input/Output Unit is logically divided into:
• A Fixed Part that contains dedicated controls for audio functions.
• An Assignable Part that contains general-purpose controls. These may be
assigned to the various sections of audio parameters available within the
Channel Strip.
This latter part is referred to as the LACP, standing for Local Assignable
Control Panel.
Controls (Fixed Part):
IN 1
This selects the first of three inputs to be used for the channel.
The input can be connected via the integrated DSP matrix (the Global
Patch) to any source available within the DSP frame.
For GROUP, MASTER, and AUX MASTER channels, Input #1 is auto-
matically assigned to the corresponding summing bus output.
This key also allows selection/de-selection of the channel's input selection
when using the copy and clear parameter facilities.
IN 2
This selects the second of three inputs to be used for the channel.
The input may be connected via the integrated DSP matrix to any source
available within the DSP frame. This key also allows selection/de-
selection of the channel's bus assignments when using the copy and clear
parameter facilities.
GEN
This selects the third of three inputs to be used for the channel, normally
the Test Generator signal.
The Test Generator is a global resource that can be accessed from all
channels. The operator can still select a different signal to this input, via
the integrated DSP matrix, the same as for IN 1 and IN 2.
This key also allows selection/de-selection of the channel's meter position
when using the copy and clear parameter facilities.
SW V3.3 Date printed: 03.09.03