Studer D950 Operating Instructions Manual page 416

D950/Vista7 Digital Mixing System
Glide Behaviors:
Setting the Glide Time:
5-86 AutoTouch+
Glide can be set to operate before or after the "Write To:" transition points
<Option>. Glide will always operate after the "Extend Back To:" transi-
tion points when enabled.
Glide behaviors at transition points are described below:
• Glide After Transition Point:
- "Write To:" At the Record Data to Read Mix Data transition, Glide
functions will start at the transition point and continue until the
Read Mix Data values have been restored. Glide will take place af-
ter the Punch-out, Next Change or Fixed End location (if possible).
- "Extend Back To:" At the Read Mix Data to Record Data transi-
tion, Glide functions will start at the transition point and continue
until the Record Data values have been reached. The Glide will take
place after the Punch In or Begin location.
• Glide Before Transition Point (Back Time enabled <Option>): This
feature is only available for "Write To:" data transitions and at the end
of the Write Zone when AutoPunch is used.
- "Write To:" At the Record Data to Read Mix Data transition, Glide
functions will start before the transition point by the amount of the
Glide Time. The Glide will continue until the Read Mix Data val-
ues have been restored (at the specified transition point). The Glide
operation will be completed by the Next Change or End location.
For example, if a three second Glide is applied with "back time"
enabled, the control will start gliding back to its Read Mix data
three seconds before its "Write To:" transition point.
The Glide Time period of time it takes for controls to glide from their Re-
cord values to their Read Mix values. This time can be any value between
00:00:00.00 and 23:59:59.2x and is specified via the Glide Time entry
field on the AutoTouch+ screen on the D950 GC. Glide times can be typed
in or entered using the roller method.
Right-clicking the Glide Time entry field will open the Entry Field Right-
click menu. This menu contains several items that assist the user in quickly
entering timecode values.
SW V3.3 Date printed: 27.08.03