D19M Series Demux - Studer D950 Operating Instructions Manual

D950 Digital Mixing System
8.4.2

D19m Series DEMUX

Front view (this example shows all available cards but not a practical configuration) :
AESO AESO AESO
SUPPLY SUPPLY SUPPLY
Rear view:
POWER
100-120V~
200-240V~
RS 422
STATUS
9p D f
8-10 Technical Specs
AESO C4DA C4DA C4DA
SYNC SYNC SYNC
EXT EXT EXT
AES1 AES1 AES1
AES2 AES2 AES2
SUPPLY SUPPLY SUPPLY SUPPLY
SYNC IN
f
SYNC OUT
POWER LINK
For analog line or digital AES/EBU outputs, the D19m series converters
are used. The D19m DEMUX frame can be used in the demultiplexer
mode with a MADI input containing all the individual converter inputs, or
in the individual mode with AES/EBU inputs to the converters. The MADI
optical connections to the D19m frame are done on the front of the rack
directly onto the MADI card, and the optical cables are guided through a
suitable cable duct to the back of the frame. The analog outputs and the
AES/EBU inputs are all located at the back of the D19m frame on a
selection of connector panels:
• 1 Siemens 39 pin connector per panel (standard for analog signals).
• 1 D-type 15 pin connector per panel (standard for AES/EBU signals).
• 4 XLR connectors per panel (on request).
• 4 BNC connectors per panel (on request).
The exact number and type of the connector panels depends on actual
project specification. For more details on D19m cards and information on
optional connector panels, refer to the Studer D19m brochure (english:
10.26.3441, german 10.26.3430).
SW V3.3
MADI MADI POWER SUPPLY +5V POWER SUPPLY ±15V
MADIOK MADIOK
MADI MADI
ON
T T
H H
R R
5V
U U
I I
N N
T
H
R
U
I
N
SYNC SLAVE SYNC SLAVE
SUPPLY SUPPLY
15p 15p
D D
m m
39p
Siem
m
Date printed: 03.09.03
ON
+15V
-15V
15p 15p
D D
m m