Function Controls - Studer D950 Operating Instructions Manual

5.16.2.5

Function Controls

Copy Picked on OK:
Open Mix Selector Tabs:
Date printed: 27.08.03
A set of function controls are provided below the Channel/Object Selector
panels. These function buttons are as follows:
Copy: copies the Selected Objects Set to the PC clipboard;
Paste: pastes the contents of the PC clipboard (copied Selected Objects Set) to
the Object Picker;
Save...: saves the Selected Objects Set as a file;
Load: allows saved object files to be reloaded;
Clear: clears the selection of all objects;
Apply: selects the objects chosen in the Object Picker for editing;
if checked, the Selected Objects Set is copied to the clipboard when the
"Apply" button is clicked;
Cancel: cancels changes made to the Selected Objects Set since the last set was
applied, saved, loaded, copied, or pasted.
Once an object or set of objects has been selected in the Object Picker,
they are then selected for editing by clicking the "Apply" button. The se-
lected objects from the selected channels will be displayed in the "Selected
Objects" window. Those are the only objects that will be affected when
edits are performed.
Note: If an object has been chosen but a channel has not, the object will not be
selected for editing when the "Apply" button is clicked.
A set of tabs, each of them representing a mix, are located at the bottom of
the Object Picker window (bottom left in the picture above). Every mix
that is currently open in the OFLA has its own tab. When the mix selector
menus are set to "Selected Mix", these tabs are used to choose a mix by
simply clicking on the appropriate tab.
SW V3.3
D950/Vista7 Digital Mixing System
AutoTouch+ 5-135