Control Mode Entry; Global Mode Entry - Studer D950 Operating Instructions Manual

D950/Vista7 Digital Mixing System
5.6.5

Control Mode Entry

5.6.5.1

Global Mode Entry

Global Control Mode Entry:
D950:
Global Mode Activators:
5-50 AutoTouch+
Controls may be put into the various Control Modes using one of four
methods:
1. Globally using the Global Control Mode Activator keys and other
controls on the Master Automation Panel.
2. Locally using the channel strip AUTO MODE key.
3. Remotely from the CAS using Control Mode Activator keys.
4. When AutoTouch+ is turned On using the MIX ON key on the Automa-
tion Master Panel. Activating the system will engage the Control Mode
selected on the Panel Presets Options page.
Note: Multiple Control Modes may be active on the console simultaneously.
The primary method to enter automation Control Modes is using the Con-
trol Mode section of the Master Automation Panel. Controls that are to
enter the mode are "Pre-Selected" using Control Mode Pre-Selector keys.
The Pre-Selected controls are then entered into the desired mode using the
Global Mode Activator keys.
Pre-Selectors
Global Mode Activators
There is an activator key for each Control Mode. Pressing one of these
keys puts the Pre-Selected controls on all channels <Option> into that
mode. The controls affected are filtered by the Pre-Selectors that are cur-
rently active. For example, when only the Fader Pre-Selector is active and
the Write Enable activator is pressed, only the faders on all channels will
change to WRITE ENABLE. Any other Control Modes that were set on
controls other than faders will retain their mode state <Option>.
Note: When a Global Mode Activator key is lit, it indicates the Control Mode for
all channels. Mode changes made on individual channels will cause the
light to go out. Resetting all the Control modes to match on the local level
will not cause Global Mode Activators to re-light.
SW V3.3
Vista:
Date printed: 27.08.03