Studer D950 Operating Instructions Manual page 509

Date printed: 27.08.03
[7] Write Zone is defined by a BEGIN and an END timecode value. If acti-
vated, automation data can be written in this zone only.
If "Auto Punch In" is checked, Write enabled parameters will punched in
automatically at the write zone beginning and punched out at the write
zone end.
If "Sync w/Loop Pts" is checked, the selected locator points in the machine
control window will be used as Write zone BEGIN and END points.
[8] Pass; shows the Begin and End time of the current mix pass.
[9] Mix; shows the Begin and End time of the entire mix.
[10] The timecode window displays the current timecode (hh, min, s, frames),
the frame rate, and the timecode type. Timecode type can be GEN (internal
TC Generator), 9 pin (serial TC), or LTC (external TC).
These settings are made in the Option – TC Reader/Gen menu (also refer
to chapter 4.6.5).
MIX ON / OFF indication (MIX ON key on the AutoTouch+ panel).
[11]
[12] RECORD, READY or STOPPED automation status indication.
[13] Indication if the currently touched parameter is a dynamic (D) or static (S)
object (also refer to
[14] Clear Static; when a non-dynamic parameter has been changed, this button
will lit. By clicking on the button the Static Data Buffer will be cleared,
otherwise the static information will be written in the next mix pass.
[15] Options...; (only activated if MIX is ON) Click on the this button to access
the Mix Options (also refer to
[16] Display Mode; mix pass display mode selection: it can be decided if only
Mix Pass number, only Mix Pass name or both shall be displayed (also re-
fer to chapter 5.4.1.3
SW V3.3
D950/Vista7 Digital Mixing System
chapters 5.3.1.1 and 5.3.1.2).
chapter 5.21).
for details).
AutoTouch+ 5-179